A STUDY OF FAECAL COLIFORM DIE-OFF IN SEWAGE SLUDGE DRYING BED
DOI:
https://doi.org/10.4314/njt.343.988Keywords:
Assessment, Coliform die-off, Sludge drying bedAbstract
The aim of this study was to assess the interacting characteristics of sewage sludge such as temperature, pH, and moisture content of sludge at defined time intervals as to how they affect Coliform die-off in a drying bed. Samples were collected at 0.0mm depth (i.e. surface of sludge), 60mm, 120mm, 180mm and 240mm, and colony count tests were performed on the samples. Results indicate that the number of Coliforms was minimum at the surface, maximum at 60mm depth, and decreased consistently to another minimum value at 240mm depth. This trend could be as a result of the organisms being in their exponential phase with adequate nutrients and growth conditions at 60mm depth, which later experienced decrease in available nutrients, oxygen and unfavorable growth conditions such as unfavorable temperatures, reduced moisture content, acidic pH and water activity. Range of the maxima and minima values of CFU/100ml for the five horizons considered over a period of 76 days were This finding does not conform with the work of Al Malack and others [6] because from their results, the various pathogenic organisms studied were found to survive longer as the sludge initial depth was increased. Short-term and long-term effect of drying indicate that low moisture content favours microbial decay because pathogen removal rate was consistently increasing from 21/01/2013 to 08/02/3013, a condition which started prevailing when the moisture content of sludge in the drying bed had decreased from 88.99 per cent on 29/11/2012 to 65.48 per cent on 21/01/2013. It was recommended that conditioners should be used to dewater sludge faster in order to speed-up pathogen die-off rate in drying beds.
Downloads
Issue
Section
License
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.