SIZING OF WIND POWERED AXIAL FLUX PERMANENT MAGNET ALTERNATOR USING ANALYTICAL APPROACH
DOI:
https://doi.org/10.4314/njt.354.1187Keywords:
Wind-Power, Axial flux, Axial Flux Permanent Machines (AFPM), Axial Flux Permanent Magnet Alternator (AFPMA), Neodymium Iron Boron (NdFeB)Abstract
The demand for a more sustainable energy supply worldwide is constantly growing hence, leading to the exploration of various renewable energy sources in energy generation systems especially in the demand for power in homes, industrial sectors and other utilities. Hydro power, wave power, solar energy, biomass and wind power are only a few that are being harnessed in various capacities. With new advances in wind energy technologies and energy conversion systems, a perfect fit is found in the utilization of wind in developing direct drive energy conversion systems. In this work, a wind-powered, single-phase, permanent magnet alternator utilizing an axial flux distribution system is developed. Using analytical calculations, the design parameters of the alternator’s main dimensions were obtained in a similar procedure for conventional electrical machines. To prove the feasibility of the concept, a prototype was built and tested. The alternator was built using Neodymium Iron Boron (NdFeB), a permanent magnet, with high concentration of flux around its periphery. The stator is slot-less and carries a concentrated air-cored type of winding. The procedures leading to either the selections and/or calculations for the machine parameters were carried out from first principle and fundamental assumptions in electrical machines design were made accordingly. Tests were conducted to determine its voltage output and were found optimal giving the abound limitations as stated.
Downloads
Issue
Section
License
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
How to Cite
