OPTIMIZATION DESIGN OF GROUND GRID MESH OF 132/33KV SUBSTATION USING ETAP
DOI:
https://doi.org/10.4314/njt.354.1188Keywords:
ETAP, ground grid mesh, design, optimization, finite element method, short-circuit currentAbstract
This paper presents ground grid mesh design analysis and optimization of a 132/33kV substation. Ground grid mesh is made up of horizontal and vertical conductors connected with vertical rods buried under substation ground. The function of this structure is to effectively dissipate extremely high current generated in the system. The objective of this study is to determine the cost effective and safe ground grid mesh parameters by comparing mesh design analysis using IEEE and Finite Element Analysis (FEM) methods. The two methods are used differently to determine the ground grid mesh parameters, step & touch voltages, horizontal and vertical number of conductors, vertical numbers of rods, and final substation Resistance. Etap 12.60 software is used for the analysis. Firstly, expected maximum short circuit current of OHIA 132/33kV substation is determined. Secondly, analysis is performed to determine input and output parameters of grid mesh structure using IEEE and FEM methods. An optimized result of IEEE method is determined. Analysis of both results is shown in different tables and recommendation is given regarding the best method for the grid mesh design.
Downloads
Issue
Section
License
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
How to Cite
