PREDICTION OF SHEAR RESISTANCE FACTOR IN FLAT SLABS DESIGN  USING CRITICAL PERIMETER OF SUPPORTING COLUMNS

FO Idagu; NM Ogarekpe; TI Ugama

doi:10.4314/njt.361.1206

PREDICTION OF SHEAR RESISTANCE FACTOR IN FLAT SLABS DESIGN USING CRITICAL PERIMETER OF SUPPORTING COLUMNS

Authors

FO Idagu DEPT. OF CIVIL ENGINEERING, CROSS RIVER UNIVERSITY OF TECHNOLOGY, CALABAR, CROSS RIVER STATE. NIGERIA
NM Ogarekpe DEPT. OF CIVIL ENGINEERING, CROSS RIVER UNIVERSITY OF TECHNOLOGY, CALABAR, CROSS RIVER STATE. NIGERIA
TI Ugama DEPT. OF CIVIL ENGINEERING, UNIVERSITY OF AGRICULTURE MAKURDI, PMB 2373 MAKURDI, BENUE STATE. NIGERIA

DOI:

https://doi.org/10.4314/njt.361.1206

Keywords:

Flat Slabs, Punching Shear, Codes Formulations, Unbalanced Moment, Eccentricity

Abstract

The distribution of shear stresses at the slab–column connection of flat slabs become non–uniform in the presence of unbalanced moment. The shear resistance (?) factor is used to account for this distribution of shear stresses due to the transfer of unbalanced moment at the slab–column connections. The provisions of the American, Canadian, European and Model codes, regarding the transfer of unbalanced moment at slab–column connections of flat slabs are compared. The relationship of ?-factor to the ratio of critical perimeter to the control perimeter of an internal column have been plotted as a simplified approach and additional approximate factors have been found for an internal corner column and various locations of cantilevered edge, corner and internal corner columns encountered in practice by engineers. These additional approximate factors have been proposed for inclusion in European code for situations where adjacent spans do not differ by more than 25%.

http://dx.doi.org/10.4314/njt.v36i1.1

Downloads

Issue

Vol. 36 No. 1 (2017)

Section

Building, Civil & Geotechnical Engineering

License

The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.

NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.

A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf

For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.

It is forbidden to publish the same research report in more than one journal.

How to Cite

PREDICTION OF SHEAR RESISTANCE FACTOR IN FLAT SLABS DESIGN USING CRITICAL PERIMETER OF SUPPORTING COLUMNS. (2016). Nigerian Journal of Technology, 36(1), 1-6. https://doi.org/10.4314/njt.361.1206