EXPERIMENTAL AND ANALYTICAL COMPARISON OF TORSION, BENDING MOMENT AND SHEAR FORCES IN REINFORCED CONCRETE BEAMS USING BS 8110,  EURO CODE 2 AND ACI 318 PROVISIONS

CP Amulu; CA Ezeagu

doi:10.4314/njt.363.1380

EXPERIMENTAL AND ANALYTICAL COMPARISON OF TORSION, BENDING MOMENT AND SHEAR FORCES IN REINFORCED CONCRETE BEAMS USING BS 8110, EURO CODE 2 AND ACI 318 PROVISIONS

Authors

CP Amulu DEPARTMENT OF CIVIL ENGINEERING, NNAMDI AZIKIWE UNIVERSITY, AWKA. ANAMBRA STATE NIGERIA.
CA Ezeagu DEPARTMENT OF CIVIL ENGINEERING, NNAMDI AZIKIWE UNIVERSITY, AWKA. ANAMBRA STATE NIGERIA.

DOI:

https://doi.org/10.4314/njt.363.1380

Keywords:

bending moment, shear force, torsional moment, codes, reinforcement

Abstract

This study investigated the effect of combined actions of torsional moments, bending moments and shear forces in reinforced concrete beams with concrete compressive strength of 30N/mm².The ultimate torsional moments, bending moments, and shear forces of the beams were determined experimentally, through a simple test arrangement set-up on fifteen beam specimens grouped from BC1 to BC5, three beam specimens in each group. The combined loads were induced by loading the test beams at an eccentricity of from the beam’s principal axis at the mid-span, using Computerized Universal Testing Machine TUE-C-100. BS 8110, Euro code 2 and ACI 318 were used to calculate the ultimate torsional moments provided by both longitudinal and transverse reinforcements, bending moments and shear forces induced. The values obtained from the codes were compared with those of experimental results for validation. It was observed that Eurocode 2 predicted the highest bending moment of 21.1530kNm, the highest torsional moments of 9.8470kNm and 12.6193kNm, for torsional resistance provided by longitudinal and transverse reinforcements respectively, at an angle crack of 45°, while BS 8110 predicted the least values. ACI 318 predicted the highest value of internal shear forces that the beams possessed before yielding to the applied loads.

http://dx.doi.org/10.4314/njt.v36i3.7

Downloads

Published

2017-06-30

Issue

Vol. 36 No. 3 (2017)

Section

Building, Civil & Geotechnical Engineering

License

The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.

NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.

A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf

For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.

It is forbidden to publish the same research report in more than one journal.

How to Cite

EXPERIMENTAL AND ANALYTICAL COMPARISON OF TORSION, BENDING MOMENT AND SHEAR FORCES IN REINFORCED CONCRETE BEAMS USING BS 8110, EURO CODE 2 AND ACI 318 PROVISIONS. (2017). Nigerian Journal of Technology, 36(3), 705-711. https://doi.org/10.4314/njt.363.1380