DESIGN AND IMPLEMENTATION OF A MICROCONTROLLER-BASED ADJUSTABLE VOLTAGE AUTOMATIC BATTERY CHARGER
DOI:
https://doi.org/10.4314/njt.364.1496Keywords:
Burst Charge, Depth-Of-Discharge DOD, Pulse Charge, State-Of-Charge SOC, Trickle charge, Duty Cycle.Abstract
Battery chargers come in different shapes, sizes and capacities, but it is difficult (if not rare) to find one charger unit that regulates overcharge and can charge different battery voltages. This work uses the basic electrical principles and ICs, to design a user friendly charger circuit that manually adjusts the voltage depending on the voltage of the battery, (6volts, 9volts and 12volts was considered because it is generally available). The circuit charges in three modes namely: Burst charging, trickle charging and pulse charging. It also incorporates a Liquid Crystal Display (LCD) to display the voltage that is being charged. The circuit also uses a Pulse Width Modulator (PWM) in order to control the duty cycle and voltage. The circuit also has an overcharge and over discharge protection. This remarkable charger saves the user time and resources needed to purchase three different chargers for three batteries, with different voltages. From the result obtained the built battery charger was able to charge 6volts (10Ah), 9volts (1200mAh) and 12volts (10Ah) battery to 100% state of charge. The charging time for the 6volts battery was 2hours 24 minutes, 2 hours 36 minutes for the 9volts battery and 2 hours 30 minutes for the 12volts battery.
Downloads
Published
Issue
Section
License
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.