POTENTIAL OF GLASS CULLET AS AGGREGATE IN HOT MIX ASPHALT
DOI:
https://doi.org/10.4314/njt.372.1664Keywords:
Glass cullet, Glasphalt, Hot mix asphalt, Optimum bitumen content, wearing course, Marshall test, Aggregate.Abstract
The increasing quantity of non-biodegradable waste has posed major environmental concern especially in the developing countries. To improve such challenge, the effects of crushed waste glass bottles (cullet) as partial replacement of fine aggregate in the properties of Hot Mix Asphalt (HMA) was investigated. The waste glass was crushed and sieved through series of sieves to determine its gradation. The optimum bitumen content (OBC) was determined using Marshall Mix Design Method. A total of 33 cylindrical specimen of asphalt produced with sand and sand partially replaced with glass cullet were prepared. 15 specimen were used to determine the OBC using of 5.0, 5.5, 6.0, 6.5 and 7.0 % bitumen to the total blended aggregate weight. The remaining samples were used to investigate the effects of glass cullet on the bituminous mixture at the selected OBC using Marshall Test. The results of the laboratory tests indicate OBC of 5.9%. Stability, flow, specific gravity and air voids were determined from the Marshall test and were compared with those specified by The Asphalt Institute and the Nigerian codes for Roads and Bridges. Optimum glass cullet content of 8.0 % was obtained. Asphalt produced with 8 % glass cullet can be used as wearing course material. Use of glass cullet will provide an effective way of disposing the waste.
Downloads
Published
Issue
Section
License
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
How to Cite
