DEVELOPMENT OF AN IMPROVED EARTHING METHOD FOR POWER AND DISTRIBUTION TRANSFORMERS SUBSTATIONS
DOI:
https://doi.org/10.4314/njt.373.1779Keywords:
Equipment, Grounding, Earthing, Earth-rod, Flowchart, Earth Mat, Flow Process, Injection Substation, Distribution Substation, Earth Resistance, IEEE Standard.Abstract
Engineers and planners have realized that equipment grounding is a necessary part of installation process in Electrical power substations. Over years, grounding or earthing has been carried out primarily through preparation of Earth Mat which is interconnected with several Earth-rods buried around the equipment under consideration. This approach takes several efforts to have an acceptable and reliable result. However, this paper presents a more flexible, economical and results oriented approach. A flow chart which describes the procedures of carrying out the proposed method of earthing is developed. This was applied to two case studies: a proposed Power transformer substation and distribution Transformer substation located within the same geographical domain. On the two cases, the measured earth resistances are presented and discussed. The results from the case study indicates that the earth resistance values obtained from this new approach are reliable and in compliance with IEEE Standards 80,142, 81 and 1100.
Downloads
Published
Issue
Section
License
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
How to Cite
