HYBRID COOLING SYSTEM FOR INDUSTRIAL APPLICATION
DOI:
https://doi.org/10.4314/njt.41.343Abstract
A hybrid cooling System was constructed and tested for glass-ware and plastic-ware production. The unit utilizes water-in-air stream to cool molds in glass and plastic forming processes. The rate of heat transfer between the mold surface and the two component two-phase stream was increased more than five times over that achieved by using the gas (air) phase alone. The enhanced cooling rate yielded speed increase in production by about 65%. The system also reduced the level of noise due to air blast at the press by limiting the use of compressed air. This cooling unit could also be used in iron and steel industries.
Downloads
Issue
Section
License
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
How to Cite
