SECONDARY CREEP RESPONSE OF HAND LAY-UP GRP COMPOSITES
DOI:
https://doi.org/10.4314/njt.221.458Keywords:
Secondary Creep Rate, Temperature Stress DependenceAbstract
Glass Reinforced Plastics (GRP) composite load bearing components are now in common use, quite often at temperatures above the ambient, where creep behaviour may be significant, as in pressurized industrial containers. This is especially true of those composites produced by the Hand Lay-Up Contact Moulding Technique, which may possess some production defects. Creep in an engineering material depends on the temperature as well as the stress level within the material. This paper examines the Secondary Creep Strain and Strain Rate of Hand Lay-Up GRP composites subjects to uniaxial stress at an elevated temperature. Empirical expressions are sought to relate Creep Strain Rate and Stress Level with time at the Secondary Creep stage. The Secondary Creep Strain Rate at a given stress level is found to be approximately constant and increases with the stress.
Downloads
Issue
Section
License
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
How to Cite
