PERFORMANCE OF STEEL SLAG AS FINE AGGREGATE IN STRUCTURAL CONCRETE

KA Olonade; MB Kadiri; PO Aderemi

doi:10.4314/njt.343.961

PERFORMANCE OF STEEL SLAG AS FINE AGGREGATE IN STRUCTURAL CONCRETE

Authors

KA Olonade DEPARTMENT OF CIVIL ENGINEERING, OBAFEMI AWOLOWO UNIVERSITY, IFE, OSUN STATE. NIGERIA
MB Kadiri DEPARTMENT OF CIVIL ENGINEERING, OBAFEMI AWOLOWO UNIVERSITY, IFE, OSUN STATE. NIGERIA
PO Aderemi DEPARTMENT OF CIVIL ENGINEERING, OBAFEMI AWOLOWO UNIVERSITY, IFE, OSUN STATE. NIGERIA

DOI:

https://doi.org/10.4314/njt.343.961

Keywords:

structural concrete, steel slag, fine aggregate, compressive strength and flexural strength

Abstract

Suitability of using steel slag (SS) as substitute for sand in concrete was investigated. SS was collected from a dump site, crushed manually and sieved through between sieves No. 4 and 200. SS was characterized using XRF and XRD techniques. Concrete of mix ratio 1:2:4 was batched by weight with slag replacement levels of 0 to 100% of sand at 25% interval and the concrete specimens (cubes and beams) produced were cured in water for 7, 14, 28 and 56 days. Water demand, compressive strength as well as flexural strength of the concrete were determined. Results indicated that SS contained high amorphous silica (42.40%) and ferric oxides (31.90%) with traces of crystalline particles. The water-cement ratio reduced from 0.62 to 0.50 as slag proportion increased from 0% to 100% at slump range of 6010 mm. The strength of SS concrete increased with increase in proportion of SS. The study suggested that up to 50% of weight of sand could be replaced with slag to produce structural concrete.

http://dx.doi.org/10.4314/njt.v34i3.4

Downloads

Issue

Vol. 34 No. 3 (2015)

Section

Building, Civil & Geotechnical Engineering

License

The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.

NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.

A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf

For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.

It is forbidden to publish the same research report in more than one journal.

How to Cite

PERFORMANCE OF STEEL SLAG AS FINE AGGREGATE IN STRUCTURAL CONCRETE. (2015). Nigerian Journal of Technology, 34(3), 452-458. https://doi.org/10.4314/njt.343.961