ANALYTICAL BENDING SOLUTION OF ALL CLAMPED ISOTROPIC RECTANGULAR PLATE ON WINKLER’S FOUNDATION USING CHARACTERISTIC ORTHOGONAL POLYNOMIAL
DOI:
https://doi.org/10.4314/njt.363.1382Keywords:
Analytical solution, Winkler foundation, Isotropic rectangular plate, Characteristic Orthogonal Polynomials, works method.Abstract
The analytical bending solution of all clamped rectangular plate on Winkler foundation using characteristic orthogonal polynomials (COPs) was studied. This was achieved by partially integrating the governing differential equation of rectangular plate on elastic foundation four times with respect to its independents x and y axis. The foundation was assumed to be homogeneous, elastic and isotropic. The governing differential equation was non-dimensionalised to make it consistent. The deflection polynomials functions were formulated. Thereafter, the Galerkin’s works method was applied to the governing differential equation of the plate on Winkler foundation to obtain the deflection coefficient, . Numerical example was presented at the end to compare the results obtained by this method and those from earlier studies. The percentage difference obtained for central deflection of all clamped rectangular plate loaded with UDL using the method and earlier research works for K = 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10 are: 0.000042, 0.000052, 0.000043, -0.000011, -0.000068, 0.000001, 0.000001, 0.000001, -0.000001, 0.000000, 0.000001. 0.000033, 0.000035, 0.000033, -0.000018, -0.000072, -0.000003, -0.000003, -0.000003, 0.000002, -0.000002, -0.000001. The result showed that an easy to use and understandable model was developed for determination of deflections of all clamped rectangular plates on Winkler’s elastic foundation using principle of COPs.
Downloads
Published
Issue
Section
License
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
How to Cite
