COMPARATIVE STUDY OF IKIRUN AND OSOGBO SLAG ON CONCRETE GRADE 20
Abstract
This study examined the use of Prism Steel Slag (PSS) and Machine Iron Slag (MIS) as partial replacement of coarse aggregate in concrete. Coarse aggregates were partially replaced with PSS and MIS at 0%, 10%, 20%, 30%, 40% and 50% respectively. A total of 132 concrete cubes of sizes 150 mm x 150 mm x 150 mm were cast and cured in water for 7, 14, 21 and 28 days respectively. Mix ratio of 1:2:4 was adopted with w/c ratio of 0.45 and batching was done by weight. The slump result indicated that the fresh concrete becomes stiff as the percentages of PSS and MIS increases. However, the compressive strengths of concrete cubes increased as the curing ages increases. 50% PSS and 40% MIS can successfully be used as partial replacement of coarse aggregate in the production of concrete grade 20.
Downloads
Published
Issue
Section
License
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
