APPLICATION OF ALTERNATIVE II THEORY TO VIBRATION AND STABILITY ANALYSIS OF THICK RECTANGULAR PLATES (ISOTROPIC AND ORTHOTROPIC)

Authors

  • OM Ibearugbulem DEPT OF CIVIL ENGINEERING, FEDERAL UNIVERSITY OF TECHNOLOGY, OWERRI, IMO STATE, NIGERIA
  • SI Ebirim DEPT OF CIVIL ENGINEERING, FEDERAL UNIVERSITY OF TECHNOLOGY, OWERRI, IMO STATE, NIGERIA
  • LO Ettu DEPT OF CIVIL ENGINEERING, FEDERAL UNIVERSITY OF TECHNOLOGY, OWERRI, IMO STATE, NIGERIA
  • LO Ettu DEPT OF CIVIL ENGINEERING, FEDERAL UNIVERSITY OF TECHNOLOGY, OWERRI, IMO STATE, NIGERIA

Keywords:

Fundamental natural frequency, SSSS plate, SSFS plate, Ritz method, Orthotropic thick plate, Isotropic thick plate, Stability, Free vibration

Abstract

This work analysed the free vibration and stability of thick isotropic and orthotropic plates with SSSS and SSFS support conditions by applying the alternative II theory based on polynomial shape function. The total potential energy which was obtained by combining the strain energy and external work was reduced to three governing equations using Ritz method. Polynomial shape function which varies with Poisson’s ratio was substituted into the governing equation to obtain the fundamental natural frequency, linear frequency and critical buckling load. The values of frequencies of the first mode and critical loads obtained were compared with those obtained using first order shear deformation theory. For span depth ratio of 10, the fundamental linear frequency for orthotropic SSFS plate corresponding to modulus of elasticity ratios (E1/E2) of 10, 25 and 40 are 0.00156, 0.00219 and 0.00255Hz. The corresponding values using first order shear deformation theory are 0.00152, 0.00212 and 0.00245Hz.

 

http://dx.doi.org/10.4314/njt.v39i1.6

Downloads

Published

2020-01-03

Issue

Vol. 39 No. 1 (2020): NIGERIAN JOURNAL OF TECHNOLOGY, VOL. 39, NO. 1, JANUARY 2020

Section

Building, Civil & Geotechnical Engineering

License

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.

NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.

A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf

 

For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.

 

It is forbidden to publish the same research report in more than one journal.

How to Cite

APPLICATION OF ALTERNATIVE II THEORY TO VIBRATION AND STABILITY ANALYSIS OF THICK RECTANGULAR PLATES (ISOTROPIC AND ORTHOTROPIC). (2020). Nigerian Journal of Technology, 39(1), 52-62. https://nijotech.com/index.php/nijotech/article/view/2216