A 3D MODELLING OF THE IN-CYLINDER COMBUSTION DYNAMICS OF TWO STROKE INTERNAL COMBUSTION ENGINE IN ITS SERVICE CONDITION

Authors

  • AE Ikpe DEPT OF MECHANICAL ENGINEERING, UNIVERSITY OF BENIN, P.M.B. 1154, BENIN, EDO STATE, NIGERIA
  • IB Owunna DEPT OF MECHANICAL ENGINEERING, UNIVERSITY OF BENIN, P.M.B. 1154, BENIN, EDO STATE, NIGERIA

Abstract

In this study, a two stroke internal combustion engine was successfully modeled as a closed cycle with the intake, compression, expansion and exhaust processes considered in two strokes of the reciprocating piston. The in-cylinder combusted gases with respect to air-fuel mixture of 14.4:1 in the two stroke engine model were analyzed, showing the dynamics of the combusted gases, the flame pressure and temperature trajectories. It was observed that provided compression and expansion takes place at air-fuel mixture near ideal condition (14.7:1), the combusted gas temperature which occurred in the range of 293.92-3000.60 K is directly proportional to the cylinder gas pressure which occurred in the range of 60.76-80.20 bar. With a heat transfer coefficient of 581.236 W/m2K, the maximum temperature of the IC engine material was found to be 2367.56K at equilibrium and the maximum shear stress was found to be 176 x 102 MPa (1.76 x 105 bar). The 14.4:1 air-fuel mixture implies that 26% O2, 73% N2 and 1% trace gases are the in-cylinder air constituent that will react with 1 mole of hydrocarbon to form the combusted products of 96.2% CO2, 3.2% H2O and 0.6% N2. This will vary in conditions where the air-fuel mixture changes.

 

http://dx.doi.org/10.4314/njt.v39i1.18

Downloads

Published

2020-01-03

Issue

Vol. 39 No. 1 (2020): NIGERIAN JOURNAL OF TECHNOLOGY, VOL. 39, NO. 1, JANUARY 2020

Section

Chemical, Industrial, Materials, Mechanical, Metallurgical, Petroleum & Production Engineering

License

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.

NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.

A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf

 

For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.

 

It is forbidden to publish the same research report in more than one journal.

How to Cite

A 3D MODELLING OF THE IN-CYLINDER COMBUSTION DYNAMICS OF TWO STROKE INTERNAL COMBUSTION ENGINE IN ITS SERVICE CONDITION. (2020). Nigerian Journal of Technology, 39(1), 161-172. https://nijotech.com/index.php/nijotech/article/view/2233