TWO PHASE FLOW SPLIT MODEL FOR PARALLEL CHANNELS
DOI:
https://doi.org/10.4314/njt.31.341Abstract
A model has been developed for the determination of two phase flow distributions between multiple parallel channels which communicate between a common upper and a common lower plenum. It utilizes the requirement of equal plenum to plenum pressure drops through the channels, continuity equations at the lower plenum channel intake boundaries, together with phase-split relationships at the channel inlets, to set up a series of nonlinear simultaneous equations. The equations are solved using the Broyden’smethod [4], a modification of the Newton’s method.
The model and code are capable of handling single and two phase flows, steady states and transients, up to ten parallel flow paths, simple and complicated geometries, including the boilers of fossil steam generators and nuclear power plants. A test calculation has been made with a simplified three-channel system subjected to a two-phase flow transient, and the results have been very encouraging.
Downloads
Issue
Section
License
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.

