DESIGN AND DEVELOPMENT OF A SMALL-SCALE BIOMASS DOWNDRAFT GASIFIER

Authors

  • PE Akhator DEPT OF MECHANICAL ENGINEERING, UNIVERSITY OF BENIN, P.M.B. 1154, BENIN, EDO STATE, NIGERIA
  • AI Obanor DEPT OF MECHANICAL ENGINEERING, UNIVERSITY OF BENIN, P.M.B. 1154, BENIN, EDO STATE, NIGERIA
  • EG Sadjere DEPT OF MECHANICAL ENGINEERING, UNIVERSITY OF BENIN, P.M.B. 1154, BENIN, EDO STATE, NIGERIA

Keywords:

Bioenergy, Biomass, Downdraft gasifier, Gasification, Renewable energy, Synthesis gas, Wood waste.

Abstract

This study focused on the design and testing of a downdraft gasifier. The gasifier design was based on a combination of the Imbert and stratified models with some modifications. Sizing of the gasifier was done using empirical relations and some experimental data relating to specific gas generation rate, biomass flow rate, throat diameter and reduction zone diameter etc. The thermal capacity of the gasifier was set at 5 kW. A cyclone separator, an air-cooling unit and a filter unit (containing wood shavings) were coupled to the gasifier’s reactor to purify the produced syngas. The gasifier system was tested in a forced draught mode using air as the gasifying medium. The feedstock conversion rate of the gasifier was 1.25kg/hr for wood chunks (10-70mm) and 2.1kg/hr for wood shavings (2-5mm). The syngas produced for both types of wood residues burnt with stable blue flames, indicating minimal tar percentage in the syngas. This signifies that the produced syngas can be safely utilized not only for cooking but also in internal combustion engines to generate electricity.

 

http://dx.doi.org/10.4314/njt.v38i4.15

Downloads

Published

2019-09-30

Issue

Vol. 38 No. 4 (2019): NIGERIAN JOURNAL OF TECHNOLOGY, VOL. 38, NO. 4, OCTOBER 2019

Section

Chemical, Industrial, Materials, Mechanical, Metallurgical, Petroleum & Production Engineering

License

The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.

NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.

A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf

 

For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.

 

It is forbidden to publish the same research report in more than one journal.

How to Cite

DESIGN AND DEVELOPMENT OF A SMALL-SCALE BIOMASS DOWNDRAFT GASIFIER. (2019). Nigerian Journal of Technology, 38(4), 922-930. https://nijotech.com/index.php/nijotech/article/view/2130